Paradise Developments - Features

Features & Finishes

Towns, Semis & Detached Homes

Purchase Price to Include:

  1. Selection of exterior colours including, brick, aluminum, roof, etc. as may be selected by the purchaser from the Vendor’s packages, if available, and if not previously ordered, or installed. The Purchaser acknowledges that the exterior colours may have been pre-selected or changed by the Vendor as a result of the Urban Design Guidelines provisions.
  2. Self sealing asphalt shingles.
  3. Windows are fully caulked and are installed with a vapour barrier.
  4. Insulated metal front entry door with weatherstripping.
  5. Sectional roll-up attached garage door.
  6. Energy efficient (low “E” argon) Energy Star qualified sliding glass patio door with screen, as per plan. Thermopane sliding patio door for most detached units only with complementing transom above for additional natural light, where size permits, as per plan.
  7. Cold cellar, as per plan.
  8. Aluminum soffits, fascias and eavestroughs, as per plan.
  9. Thermopane energy efficient (low “E” argon) Energy Star qualified vinyl casement windows on main and second floor except for garage and basement. Basement windows will be double glazed where applicable per plan. 8. Screens provided on all operating windows.
  10. Poured concrete basement walls.
  11. Driveway to be paved asphalt. (Vendor will provide base coat asphalt) The finished coat will be completed by the Vendor at the Purchaser’s expense (not refundable) to be adjusted on closing.
  12. Lot to be graded and sodded to requirements of the Municipality.
  13. Two exterior water service taps; one in the garage and one at the rear or side, as per plan. (One additional tap at front of Laneway Townhomes)
  14. Three exterior electrical outlets; one in the garage and one weatherproof outlet at the front and rear and all accessible second floor balconies, as per plan.
  15. Pre-cast cement slabs from driveway to front entrance.
  16. Exterior walls, ceiling, and basement to be insulated to Ontario Building Code standards.
  17. Quality 2’ x 6’ exterior wood frame construction.
  18. 5/8” tongue and groove subflooring throughout main and second floor, as per plan screwed down and joints sanded with an advanced Engineered Floor Joist System.
  19. Oak main staircase to feature oak stringers, handrail and pickets in natural finish from main floor to second floor, as per plan excluding stairs to basement and landings.
  20. 9’ main floor ceilings and second floor ceilings, as per plan.
  21. Quality broadloom and underpad on second floor (all models) excluding staircase to all non-tiled areas, as per plan.
  22. 2 ¼” red oak solid oak flooring from Vendor’s standard samples on main floor, including main staircase landings to all non-tiled areas (all Models).
  23. Direct vented Energy Star rated natural gas fireplace (for detached units only).
  24. Claremont Series doors and trim with quality hardware. Arches to be trimmed on main floor.
  25. Sprayed and stippled ceilings in all rooms except kitchen (as permitted per plan), bathrooms and main floor laundry room, as per plan.
  26. All interior walls, trim and doors painted with low VOC paint throughout.
  27. Ceramic floor tile in the front vestibule, foyer (as per applicable plan), kitchen and breakfast area (as per plan), laundry room (if on main or second floor) powder room, main and ensuite bathrooms as per plan from Vendor’s standard samples.
  28. Custom quality cabinets and post formed arborite countertops in kitchen (Towns and Semi Models ONLY) and bathroom vanities, as per plan selected from Vendor’s standard samples. Extra height master ensuite bathroom vanity, as per plan. Extra height kitchen upper cabinets, as per plan. *Primary Level granite countertop with standard edge from Vendor’s standard samples in kitchen and servery, as per plan (30’, 38’ & 44’ Models ONLY).
  29. Kitchen includes double stainless steel sink with single lever faucet and hood fan ducted to outside.
  30. Ceramic wall tiles in bathtub enclosure, as per plan. Bathrooms with separate shower stall have tiles around the tub and tiles to ceiling in shower stall, as per plan.
  31. Ceramic bathroom accessories.
  32. Quality plumbing fixtures in bathrooms.
  33. Single shower controls in all tubs and showers to feature temperature control valve.
  34. Chrome finish single lever taps on all sinks, basins and bathtubs excluding laundry tub.
  35. Pedestal sink and mirror in powder room, as per plan.
  36. Mirror in bathrooms and powder rooms.
  37. 100 AMP electrical service with circuit breaker panel including heavy duty cable and outlet for stove and dryer.
  38. Electric door chime.
  39. Smoke detectors on all levels as per Ontario Building Code standards and one carbon monoxide detector.
  40. Prewire for telephone service.
  41. Prewire for two (2) TV outlets, as per plan.
  42. Prewire for future home automation, 1 CAT-5 prewire to terminate in great room from basement, as per plan.
  43. Rough-in central vacuum system. Rough-in for future dishwasher (plumbing and electrical).
  44. Rough-in 3 piece bathroom in basement. (Location may vary from that shown on plan.)
  45. Energy Star qualified high efficiency forced air gas furnace and gas hot water tank contributing to energy efficiency in the home. (Location may vary from that shown on plan.)
  46. Rental of gas hot water tank. The purchaser acknowledges that the hot water tank is a rental and agrees to execute a rental agreement on or before closing with National Home Services, or other gas utility provider.
  47. Single fiberglass laundry tub and washer taps, as per plan.
  48. Taps installed for automatic washer connection.
  49. Warranty as set out by the Tarion Warranty Corporation (TARION), save and except the enrolment fee.
  50. White decora style switches and receptacles throughout.

Purchaser acknowledges that:

  1. The Vendor will not allow the Purchaser to do any work and/or supply any material to finish the dwelling before the closing date.
  2. If an item selected by the Purchaser is not available, the Purchaser must reselect from the Vendor’s samples within forty-eight (48) hours of notification, failing which the provisions of the Agreement in respect of an original selection shall prevail.
  3. Purchasers are notified that the side door (where applicable) may be lowered to accommodate side yard drainage as per grading or municipality requirements.
  4. Laundry room layout and stairs are particularly susceptible to alteration in order to accommodate building code, municipally approved grading and drainage requirements. Purchasers are notified that the number of steps to front entrance and rear entrance, landing and vestibule may be increased or decreased depending on final grading. Purchasers are notified that jogs in walls of rooms may vary from model to model to accommodate structural requirements and/or venting for the house.
  5. Main floor laundry room floor, landing and vestibules, where applicable, may be lowered to accommodate entry door(s) at the vendor’s discretion (unfinished basement ceiling height or cold cellar height shall be lowered accordingly). Some ceiling heights in various rooms, hallways and bulkheads may be lower than 9’, as per plan.
  6. Purchaser acknowledges that variations from Vendor’s samples may occur in finishing materials, kitchen and vanity cabinets, floor and wall finishes due to normal production process and any variations in colour or grain in natural wood products or manufactured flooring products including but not limited to manufactured laminate, birch, maple, oak flooring is not the responsibility of the Vendor as the flooring finish may not match the stain or finish of stairs, pickets and railings because of the difference of materials used.
  7. Purchaser acknowledges that the Tarion Warranty Corporation (TARION) enrolment fee is not included in the purchase price.
  8. HST (Provincial and Federal portions) is included in purchase price. The purchase price has been determined taking into account the HST rebate (if applicable) to which the Purchaser is assigning to the Vendor pursuant to compliance with Schedule “H” of the Agreement. The Purchaser shall reimburse the Vendor for any loss of this rebate by reason of the Purchaser’s default pursuant to Schedule “H”.
  9. SELECTIONS ALREADY MADE ON THE ABOVE ITEMS BY THE BUILDER CANNOT BE CHANGED.
  10. EXTERIOR ELEVATION, APPEARANCES AND FINISHINGS WILL BE SIMILAR TO PICTURES OR RENDERINGS BUT MAY NOT NECESSARILY BE IDENTICAL.
  11. ALL SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. LOT FRONTAGES ON SITE PLAN REFER TO THE MINIMUM WIDTH OF THE LOT AT THE FRONT BUILDING SETBACK.
  12. SOME EXTERIOR DETAILS MAY BE IN COMPLIMENTARY MATERIALS OTHER THAN BRICK INCLUDING BUT NOT LIMITED TO SIDE ROOF GABLES.